Pullbox with alarm |
|
|
|
| Product Description: | |
| Product name : Pullbox with alarm | |
| Item : alarm pullbox | |
| Details : | |
Telescopic anti-theft display rope with alarm
operation introduction
This product has two sets of detection alarm, that is, cut off the wire rope alarm, and tilt the main engine to alarm.
When the alarm condition needs to be closed, the alarm can be relieved by pressing the remote controller at the main
engine and pressing the OFF key.
180 seconds without operation automatically closes the warning tone.
If the wire rope is not damaged, the switch on the bottom of the main engine will automatically enter the state
of defense when it is pressed down.
The micro power circuit is designed for 2 years without alarm. When the battery is
quickly exhausted, it calls the "beep" warning sound in 60 seconds. After the battery is exhausted, the product has
only wire rope to pull the anti-theft function.
No electronic sounding warning function.
1. Rip up the 3M adhesive film
at the bottom of the main machine and stick it to the appropriate showcase location. (as in Figure 1)
2. As needed, lock two screws. (Figure two)
3. Turn the magnetic latch (the need for another purchase) to the side of the lock, open the lock catch,
and remove the pin. (for example, figure three)
4. Pull the wire rope, find the mainframe power switch hole from the side, use the pin to point the power switch hole
on the main engine wheel, and insert the mainframe power switch, (the power switch can not close normally once it is opened).
The host will beep for a prompt. (Figure four)
5. With the simple screwdriver attached, the size of the steel wire ring can be adjusted to the right size.
(for example, figure five)
6. Put the display in the steel wire collar and insert the pin into the lock button to
complete the installation. (for example, figure six)
7. When the alarm occurs, use the remote control (to purchase separately) to aim at the top of the host and
relieve the warning tone. (for example, figure seven)
Technical parameters:
Working voltage: 3V
Ambient humidity: <80%
Environment temperature: -10 centigrade C~60 centigrade C
Alarm sound: 85DB
Wire rope: 1.2 bags of plastic steel wire
Extension length: 120CM |
|
 |
[Next : acrylicstand]→ |
| Related Products : |
English
中文版
